Single OTO Wire Drawing Machine
The drawing process of welding wire is divided into rough drawing and fine drawing.
The rough drawing process draws the wire base material aboutФ6.0mm or Ф5.5mm that has undergone wire pretreatment to wire about Ф2.45mm.
In this drawing process, 560 series drawing machines are mostly used.
Product Details
Pulley wire drawing machine is used for the first die, and there is a certain amount of wire on the reel. When the wire is disordered during paying off, there is enough buffer time to control the whole drawing machine to slow down and stop, so as to avoid the wire breakage of the wire drawing and take-up part caused by high-speed emergency stop.
The drum is equipped with operation buttons and foot switches.
The working surface of the wire drawing drum is sprayed with Tungsten Carbide, and the surface is mirror polished, which is not only hard and wear-resistant, but also does not damage the surface of the welding wire.
The inner surface of the drum is treated by thermal Zinc spraying, which can effectively prevent scaling and prolong the maintenance and cleaning cycle.
Copper pipe is used for direct water cooling inside the drum, and the water supply and drainage pipes for cooling water of the drum and the die boxes are arranged reasonably for convenient maintenance.
The machine is equipped with inching, front linkage, rear linkage, start, stop and other functions.
Drive mode: highly efficient narrow v-belt transmission and gear reducer drive, AC motor frequency conversion drive.
The AC motor power:30KW.
